ASTM A269, ASTM A213 304 /316 L coil tube chemical component

We use cookies to improve your experience. By continuing to browse this site, you agree to our use of cookies. More information.

IntroductionSpecification Comparison Material Manufacturing Dimensional Tolerances Wall Thickness Outer Diameter Surface Finishing Weld Bead Heat Treatment  Non-Destructive TestingWhich Specification
This article provides an alternative code for Australian food services. These specifications include:
ASTM A269 “Specification for General Purpose Seamless and Welded Austenitic Stainless Steel Tubing”
ASTM A249 “Specification for Austenitic Boiler, Superheater, Heat Exchanger, and Condenser Welded Tubes”
AS1528 was revised in 2001 by key stakeholders in the Australian food and pipe industry. AS 1528 is unique in that it covers all relevant fittings except pipes.
All specifications refer to common steel grades such as 304, 304L, 316 and 316L. AS1528.1 applies to all duplex and austenitic stainless steel grades listed in ASTM A240.
All sizes require fusion-welded products without filler metal. Specifications such as ASTM A270, ASTM A269 and AS 1528 also apply to seamless products.
AS 1528 defines a nominal thickness of 1.6 mm for all outside diameters (OD) except 2 mm for OD 203.2 mm; other thicknesses may be specified by the purchaser. Standard tolerance + zero, -0.10 mm. The full negative tolerance is in line with the common practice for producing pipes of all sizes closer to the lower end of the tolerance range. A typical range is 1.52 to 1.58 mm. This tolerance also applies to fittings.
* Tolerances for ASTM A554 weld removal conditions. * AS1528 also applies to OD sizes 12.7, 19.0, 31.8, 127.0, 152.4 and 203.2 mm.
All of these pipe specifications specify limits on wall thickness and outside diameter. The inner diameter is not specified separately.
Surface treatment specifications of various sizes recommended for use in the Australian food industry are as follows:
The processing of products used in the food industry requires pipes without weld residues on the inner surface.
The mechanical properties of various grades of stainless steel commonly used in the food industry are as follows:
AZoM is speaking with NanoGraf CEO Francis Wang to discuss their new Lithium Ion battery technology and manufacturing outsourcing in the Midwest.
AZoM spoke with Dr. Katharina Marquardt ahead of International Day of Women and Girls in Science in 2023. We discuss her impressive STEM career spanning experience in disciplines ranging from mineralogy to ceramic materials.
On International Day of Women and Girls in Science, AZoM discusses their STEM research and career with Dr. Debrupa Lahiri, Associate Professor of Metallurgy and Materials Science at IIT Roorkee.
This product review from Microtrac describes the high-tech adsorption capabilities of Belsorp Max X.
APEX 400 is a dedicated solution for manual preparation of beads for XRF analysis. It can press samples in supported steel rings as well as standard unsupported sizes.
Learn more about how to increase the efficiency of your lab with LabVantage 8.8, a commercial web browser for access to all your lab information.
The global semiconductor market has entered an exciting period. Demand for chip technology has both spurred and retarded the development of the industry, and the current chip shortage is expected to continue for some time. Current trends are likely to shape the future of the industry as this continues
The main difference between graphene-based batteries and solid-state batteries is the composition of the electrodes. Although cathodes are often modified, allotropes of carbon can also be used to make anodes.
In recent years, the Internet of Things has been rapidly implemented in almost all areas, but it is especially important in the electric vehicle industry.